Lorem ipsum dolor sit amet, consectetur adipiscing elit. Ut elit tellus, luctus nec ullamcorper mattis, pulvinar dapibus leo.

Installation

Installation

This is a simplified pictures que step by step method statement for application of our recommended products onto;

Please call our sales team for a complete tailor- made and comprehensive proposal with typical details from us if necessary for your better understanding and submission purpose.

Disclaimer

All information contained herein has been compiled and presented in good faith and subject to change without notice. Corporate Excelsior (M) Sdn Bhd makes no express or implied warranty of any kind regarding the accuracy of the information contained herein or accept amy liability either direct or indirect arising from the use of its products as the company has no direct or continuous control over where or how its products are used or applied. POLYMiX products have been designed and manufactured to be in accordance with the instructions guiding their applications and are sold subject to its standard terms and conditions of sale copies of which may be obtained on request from POLYMiX sales department.

Step 1: Ceiling Soffit to be free from dirt, grease and laitance.

Step 2: Dry FMBW

Step 3: Mechanical mixing of FMBW with water for 3 minutes

Step 4: Mixed FMBW

Step 5: Leveling with FMBW as base coat with minimum 2 coats

Step 6: Smoothening Framework Joint

Step 7: Completed Base Coat

Step 8: Mechanical mixing of PFW with water for 3 minutes

Step 9: Well Mixed PFW

Step 10: Minimum 2 coats of PFW onto leveled base coat

Step 11: Completed smoothening coat

Step 1: Preparing Render for mixing

Step 2: Mixing of Render with Clean Water in rotating drum mixer for minimum 3 minutes

Step 3: Substrate preparation at corners and installation of level pegs/strips

Step 4: Building up thickness of Base plaster

Step 5: Leveling with Steel Trowel to level peg

Step 6: Wood trowel to trim and profile entire surface to level peg

Step 7: Completed Base Coat

Step 8: Application of TPG as the smoothening coat with minimum 2 coats

Step 1: Preparing CMBG for Mixing

Step 2: Mechanical Mixing with water for minimum 3 minutes

Step 3: Substrate Preparation (removing excess adhesive and filling up of joints)

Step 4: Installation of angle liners at all required corners with a smoothening overcoat(6 inches width)

Step 5: Leveling with CMBG as base coat with minimum 2 coats

Step 6: Building up thickness of CMBG with 2nd or 3rd coat until desired flatness is achieved to receive smoothening coat.

Step 7: Step 6 continues for the entire surface

Step 8: Application of TPG as the smoothening coat with minimum 2 coats

Step 9: Minimum 2 coats of PFG onto leveled base coat

Step 10: Smoothening & compressing out all trowel marks at 80% cured of PFG

Step 1: Preparing FMBG for mixing with clean water

Step 2: Mechanical Mixing for minimum 3 minutes

Step 3: After substrate preparation (removing laitances and smoothening over joints, leveling with FMBG as base coat with minimum 2 coats)

Step 4: Application of 2nd coat until desired flatness is achieved

Step 5: Preparing PFG for mixing with clean water

Step 6: Application with minimum 2 coats of PFG to smoothen onto leveled base coat

Step 7: Smoothening & compressing all trowel marks at 80% cured of PFG

Step 8: Clean trowel to prepare for last operation

Step 9: Further compressing (optional) the completed PFG surface with the wet trowel to create extra smoothness and reflective surface

Step 10: Completed smoothening coat